Details, datasheet, quote on part number: 1.5KE10CA
Part1.5KE10CA
CategoryDiscrete => TVS (Transient Transient Voltage Suppressors)
DescriptionPakage = DO-201 ;; Devices Marking Code= ;; Nominal Voltage(V) = 10
CompanyTaiwan Semiconductor (TSC)
DatasheetDownload 1.5KE10CA datasheet
Cross ref.Similar parts: 1N6382, 1N6365, 1N6142A, 1N6039A, 1N6039, 15KE10CA, 15KE10C, ICTE8C, ICT8C, 15CE10CA
Quote
Find where to buy
 
  

 

Features, Applications
Voltage Range to 440 Volts 1500 Watts Peak Power 5.0 Watts Steady State
Features

UL Recognized File # E-96005 Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Exceeds environmental standards MIL-STD-19500 1500W surge capability 100 us waveform, duty cycle: 0.01% Excellent clamping capability Low zener impedance Fast response time: Typically less than 1.0ps from 0 volts to VBR for unidirectional and 5.0 ns for bidirectional Typical IR less than 1uA above 10V High temperature soldering guaranteed: / 10 seconds /.375",(9.5mm) lead length / 5lbs.,(2.3kg) tension

a Case: Molded plastic Lead: Axial leads, solderable per MIL-STD-202, Lead: Method 208 Polarity: Color band denotes cathode except bipolar Weight: 0.94gram Dimensions in inches and (millimeters)

Rating at 25C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%

Steady State Power Dissipation TL=75 C Lead Lengths.375", 9.5mm (Note 2) Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method) (Note 3) Maximum Instantaneous Forward Voltage at 50.0A for Unidirectional Only (Note 4) Operating and Storage Temperature Range

Notes: 4. VF=3.5V for Devices of VBR 200V and VF=5.0V Max. for Devices VBR>200V. Devices for Bipolar Applications Notes: 1. For Bidirectional Use or CA Suffix for Types 1.5KE6.8 through Types 1.5KE440. Notes: 2. Electrical Characteristics Apply in Both Directions.

Notes: 1. Non-repetitive Current Pulse Per Fig. 3 and Derated above TA=25OC Per Fig. 2. Notes: 2. Mounted on Copper Pad Area x 20 mm) Per Fig. 4. Notes: 3. 8.3ms Single Half Sine-wave or Equivalent Square Wave, Duty Cycle=4 Pulses Per Minutes Notes: 3. Maximum.

PEAK PULSE POWER (Ppp) or CURRENT (IPPM) DERATING IN PERCENTAGE, %
PULSE WIDTH (td) is DEFINED as the POINT WHERE the PEAK CURRENT DECAYS 50% of lPPM
PM(AV), STEADY STATE POWER DISSIPATION, WATTS
HALF VALUE- lPPM 2 10/1000 sec. WAVEFORM as DEFINED by R.E.A.
FIG.6- MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT UNIDIRECTIONAL ONLY
lFSM, PEAK FORWARD SURGE CURRENT, AMPERES
8.3ms Single Half Sine Wave JEDEC Method Tj=Tj max.
Maximum Peak Surge Current IPPM (Note 2)(Amps)

Notes: 1. VBR measured after IT applied for 300us, IT =square wave pulse or equivalent. 2. Surge current waveform per Figure 3 and derate per Figure 2. 3. For bipolar types having VWM of 10 volts and under, the ID limit is doubled. 4. All terms and symbols are consistent with ANSI/IEEE C62.35.


 

Related products with the same datasheet
1.5KE100
1.5KE100A
1.5KE100C
1.5KE100CA
1.5KE10A
1.5KE10C
1.5KE11
1.5KE110
1.5KE110A
1.5KE110C
1.5KE110CA
Some Part number from the same manufacture Taiwan Semiconductor (TSC)
1.5KE11 Pakage = DO-201 ;; Devices Marking Code= ;; Nominal Voltage(V) = 10

SMCJ26 : Pakage = SMC/DO-214AB ;; Devices Marking Code= GDW ;; Nominal Voltage(V) =

TS2937CM5 : 500ma Ultra Low Dropout Fixed Positive Voltage Regulator

1SMA120 : Surface Mount Glass Passivated Zener Diode

SR3090PT : 30.0 Amps. Schottky Barrier Rectifiers

TSS70U : 0.2amp Surface Mount Schottky Barrier Diode

BZX79C2V7RLRL2 : 20 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35 Specifications: Diode Type: VOLTAGE REGULATOR DIODE

BZX85C27-56B0 : 20 V, 1.3 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 Specifications: Diode Type: VOLTAGE REGULATOR DIODE

TSC5904CXRF : 3000 mA, 60 V, NPN, Si, SMALL SIGNAL TRANSISTOR Specifications: Polarity: NPN ; Package Type: ROHS COMPLIANT PACKAGE-3

 
0-C     D-L     M-R     S-Z