Details, datasheet, quote on part number: TC400
DescriptionTemperature Compensated Crystal Oscillators (tcxos)
CompanyVectron International
DatasheetDownload TC400 datasheet
Find where to buy


Features, Applications
Temperature Compensated Crystal Oscillators (TCXO's) TC-400 (14/4 Single DIP Series)

Vectron International has introduced a series of Temperature Compensated Crystal Oscillators (TCXO's) available in frequencies from to 160 MHz.

Industry Standard 14/4 Single DIP package Frequency from to 160 MHz 3.3 Vdc or 5 Vdc operation All outputs Available (TTL, HCMOS, PECL, Sine)

Available from 2.0 MHz to 160 MHz 5.0 Vdc 5% 3.3 Vdc 5% Current draw will vary greatly depending on frequency and output type. For this series TCXO typical current draw will be about 15 mA. Please consult the factory about your exact current requirements. HCMOS/ACMOS 10 TTL PECL 0 dBm/50 ohm to 160 MHz to 160 MHz to 160 MHz to 77.76 MHz

Note: Not all stabilities are available with all frequency/output combinations. Please consult the factory.

x 10-6 over x 10-6 over x 10-6 over x 10-6 over x 10-6 over x 10-6 over x 10-6 over x 10-6 over to +85C

NOTE: Tighter stabilities and wider temperature ranges are available, please consult the factory.

<10 ppm for ten years +70C <0.2 ppm for a 5% change in supply voltage A = Electrical Frequency Adjust 10 ppm minimum via external voltage, 0 to Vdd - positive slope B = Tri-state HCMOS/TTL Enable/Disable PECL = No connect Initial Accuracy 2.5 ppm x 0.405")

Vectron International 267 Lowell Road, Hudson, NH 03051 Tel: 1-88-VECTRON-1 Web:
Output Option A Output Voh min.. Vol max. HCMOS/ACMOS 0.8 (Vdd) +0.5 Vdc 100 k ohm 5 ns max.

B 10 TTL +2.4 Vdc +0.5 Vdc 10 TTL 10 ns max. F Output Option PECL Output Vdd - 1.04 Vdc Level Vcc -1.60 Vdc Load

Product Family TC = TCXO Package = 14/4 DIP Supply Voltage = 5.0 Vdc = 3.3 Vdc 5%

Output Frequency 2.0 MHz to 160 MHz Pin 1 Options A = Electrical Frequency Adjust (Default) B = Tri-state or Enable/Disable = No Connect Temperature Range = 1.0x10-6 over = 1.5x10-6 over = 1.0x10-6 over = 1.5x10-6 over = 1.5x10-6 over 2.0x10-6 over = 1.5x10-6 over = 2.5x10-6 over to +85C

Note: Other stabilities are available upon request.


Some Part number from the same manufacture Vectron International
RGR7HYA17C10 Temperature Compensated Crystal Oscillators
TFS403 Filter Specification
F308 OCXO Surface Mount Package Optional Reflow Process Compatible Optional At-cut and Sc-cut Crystal Options Low Profile Compact Package
MQF21.0-1200-03 Monolithic Crystal Filter
CCFDEA-25M125 3.3, 5.0 volt CMOS Oscillator
SV033 Standard 4-pin DIP Package Enable Function
CDTHLJ-25M125 3.3, 5.0 volt CMOS Oscillator
VDUHLA-44.736 Voltage Controlled Crystal Oscillator
TFS38C Filter Specification
HCS5HXB37C15 Temperature Compensated Crystal Oscillators
CDFHDA-25M125 3.3, 5.0 volt CMOS Oscillator

OC-260-CAF-207BC : Frequency Range = 1MHz - 80MHz ;; Output Logic = Hcmos Sine ;; Package = 25.7 X 25.7 X 13.2mm ;; Features = Low Profile

OC-290-DGF-ST3CA-10.0 : Oven Controlled Crystal Oscillators

MQF21.4-1200 : Monolithic Crystal Filter

XO-400-CFF-G-125.0000MHZ : Crystal Oscillators ( XOs )

VCUGLD-44.736 : Voltage Controlled Crystal Oscillator

VS-750-LFF-HNN-P2-P4 : Dual Frequency VCSO

VCB1-A0A-25M00 : 3.3, 5.0 volt CMOS Oscillator

QF1.4-L0205 : Monolithic Crystal Filter

FX-104-DFC-D3C8 : Frequency Translator

FX-104-DFF-A228 : Frequency Translator

TRU050-GKCCA : Complete VCXO Based Phase-locked Loop

EX-621-DAFST3A-12.8000 : Evacuated Miniature Crystal Oscillator

Same catergory

MBR1050 : 5 to 100 Amp. 10A Schottky Barrier Rectifier. Schottky Barrier Chip Guard Ring Die Construction for Transient Protection Low Power Loss, High Efficiency High Surge Capability High Current Capability and Low Forward Voltage Drop For Use in Low Voltage, High Frequency Inverters, Free Wheeling, and Polarity Protection Application Plastic Material: UL Flammability Classification Rating 94V-0 Case:.

SK2111 : 1:10 Differential LVDS Clock Driver. to 10 data/clock distributor utilizing LVDS (Low Voltage Differential Signaling) technology for high speed operation. Data paths are fully differential from input-to-output for low noise generation and low pulse width distortion. The design allows connection of 1 input to all 10 outputs. LVDS I/O enable high speed data transmission for point-to-point.

SN54ALS874BFK : Dual 4-bit D-type Edge-triggered Flip-flops. 3-State Buffer-Type Outputs Drive Bus Lines Directly Bus-Structured Pinout Choice of True or Inverting Logic SN74ALS874B, SN74AS874 Have True Outputs SN74ALS876A, SN74AS876 Have Inverting Outputs Asynchronous Clear Package Options Include Plastic Small-Outline (DW) Packages, Plastic (FN) and Ceramic (FK) Chip Carriers, and Standard Plastic (NT) and Ceramic.

SN74F352N : Multiplexers. ti SN74F352, Dual 4-line to 1-line Data Selectors / Multiplexers.

M8R61FCJ : 9x16 mm, 3.3 Volt, Hcmos/ttl, Clock Oscillator. These are non-PLL based high frequency oscillators intended for applications that require low phase jitter. For frequencies 80.000 MHz and below, please see the M8S series. MtronPTI reserves the right to make changes to the product(s) and service(s) described herein without notice. No liability is assumed as a result of their use or application. Please.

UPC1861 : Horizontal LOCK Clock Generator.

3754/36 : Round Conductor Flat Cable. Close spacing permits higher signal density PVC insulation provides excellent flexibility 30 AWG stranded on.025 inch spacing allows for mass termination as well as increased flexibility Recommended for use with the Series.050 x.100 Tripolarized Wiremount Mini Socket (82XXX-600X) and Pak 25 (P25E-XXX-STGF) RoHS* compliant Material: Polyvinyl Chloride.

DM7489B : 64-bit Read/write Memories.

1N3842 : Silicon Planar Thyristor Diodes.

MLX90614AAA : Single and Dual Zone Infra Red Thermometer. Single and Dual Zone Infra Red Thermometer in TO-39 and Benefits Small size, low cost Easy to integrate Factory calibrated in wide temperature range: 125 C for sensor temperature and 380 C for object temperature. High accuracy 0.5 C over wide temperature range (0.+50 C for both Ta and To) High (medical) accuracy calibration optional Measurement.

C39SC-25.000M : Military Standard HIGH Temperature Oscillators. These dual in line Quartz Crystal Clock Oscillators are designed for use as clock generators and timing sources where high temperature, miniature size, and high reliability are of paramount importance. It is hermetically sealed to assure superior performance. : Temperatures to 300C Low profile: seated height only 0.200" DIP Types in Commercial & Military.

LM3508TLEV : Eval Board - Led Driver Programmers, Development System; BOARD EVALUATION FOR LM3508TL. s: Current - Output / Channel: 20mA ; Voltage - Output: 17V ; Voltage - Input: 2.7 ~ 5.5 V ; Outputs and Type: 1, Non-Isolated ; : Dimmable ; Supplied Contents: Board ; Utilized IC / Part: LM3508 ; Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant.

286-102 : BANANA JACK, 15A, STUD, RED. s: Connector Type: Banana Jack ; Series: - ; Gender: Jack ; Contact Termination: Stud / Turret ; Current Rating: 15A ; Voltage Rating: 1kV ; Contact Plating: Nickel ; Contact Material: Brass ; Connector Color: Red ; Connector Mounting: Cable.

OSTEO110100 : Free Hanging (In-Line) Terminal Block - Headers, Plug And Socket Connectors, Interconnect Plug for Unshrouded Header; CONN TERM BLOCK 11POS 5MM. s: Terminal Block Type: Plug for Unshrouded Header ; Positions Per Level: 11 ; Pitch: 0.197" (5.00mm) ; Number of Levels: 1 ; Header Orientation: - ; Plug Wire Entry: 90 ; Termination: Screw ; Wire Gauge:.

ECH8661 : 7 A, 30 V, 0.024 ohm, 2 CHANNEL, N AND P-CHANNEL, Si, POWER, MOSFET. s: Polarity: N-Channel, P-Channel ; MOSFET Operating Mode: Enhancement ; V(BR)DSS: 30 volts ; rDS(on): 0.0240 ohms ; Package Type: HALOGEN FREE, ECH8, 8 PIN ; Number of units in IC: 2.

SR12+2018MFPL1.5 : FC CONNECTOR. s: Connector / Adapter: Connector ; Connector Type: FC. Ruggedized Small Channel Count Switch Module SR Series 1x2, 2x2Compact sizeTypical IL 0.6 dBReturn loss (RL) greater than 55 dBSeveral configurations availableReliable, small modules suitable for rugged environments where vibration and shock performance are criticalSimple controlDirect or TTL control of switchingHigh repeatability over a broad range.

0-C     D-L     M-R     S-Z