Details, datasheet, quote on part number: TC-210-CBC-507A
PartTC-210-CBC-507A
CategoryTiming Circuits => Oscillators => TCXO (Temperature Controlled Oscillators)
DescriptionFrequency Range = 0.5MHz - 160MHz ;; Output Logic = TTL Hcmos Pecl Sine ;; Package = 29.21 X 25.4 X 10.03 True SMD ;; Features = Stratum 3 Option, Complementary Pecl Output
CompanyVectron International
DatasheetDownload TC-210-CBC-507A datasheet
  

 

Features, Applications

Frequency from to 160 MHz Stability as tight as 0.28 ppm Aging to <3.5 ppm for ten years Package: ) 3.3 Vdc or 5 Vdc operation All outputs available (TTL, HCMOS, PECL, SINEWAVE)

Stratum 3 Applications SONET/SDH Network Timing Sources DWDM / FDM / ATM Wireless Communications VSAT, LMDS, WLL

Vectron International has introduced a series of surface mount, Temperature Compensated Crystal Oscillators (TCXO s) available in frequencies from to 160 MHz. Model Z5 surface mount TCXO s can be mounted using the standard convection reflow process. The units can meet the 0.37 ppm Holdover requirement +70 C temperature range and operate from or 5V supply. Current drain to lower than mA is available upon request. Aging <3.5 ppm for ten years. Phase noise is -115 dBc/Hz 100 Hz and -155 dBc/Hz at 10 MHz. These units are ideal for Stratum 3 applications. For additional Stratum 3 solutions please visit our website at:

MHz, Available from 0.5 MHz to 160 MHz 1.00x 0.395 Vdc = 3.3 Vdc 5% Current draw will vary greatly depending on frequency and output type. For this series TCXO typical current draw will be about 15 mA and depending on output type may be less than 2 mA. Please consult the factory about your exact current requirements. HCMOS / ACMOS 10 TTL Complementary PECL 0 dBm / 50 ohm over to 160 MHz 160 MHz 160 MHz 100 MHz (See page 3)

Note: Other stability options are available. Contact the factory for assistance.

x 10-6 for all causes & 10 years x 10-7 for all causes and 24 Hours (Available in Temperature Ranges & C)

Stability vs Supply: Aging (typical): Electrical Frequency Adjust: Phase Noise (Typical): 10 MHz

0.1 ppm for a 5% change in Supply Voltage <3.5 ppm for ten years 5 ppm minimum via external voltage, 0 to Vdd Offset 100k Hz Phase Noise -115 dBc/Hz -145 dBc/Hz -150 dBc/Hz -155 dBc/Hz

For HCMOS / ACMOS / TTL & PECL outputs with frequencies above 35 MHz a low phase noise PLL multiplier may be used. Please inform that factory of your phase noise requirements.


 

Related products with the same datasheet
TC-210-CAB-307A
TC-210-CAB-ST3A
TC-210-CAC-507A
TC-210-CAC-ST3A
TC-210-CAF-106A
TC-210-CBB-307A
TC-210-CBB-ST3A
TC-210-CBC-ST3A
TC-210-CBF-106A
TC-210-CFB-307A
TC-210-CFB-ST3A
Some Part number from the same manufacture Vectron International
TC-210-CBC-ST3A Frequency Range = 0.5MHz - 160MHz ;; Output Logic = TTL Hcmos Pecl Sine ;; Package = 29.21 X 25.4 X 10.03 True SMD ;; Features = Stratum 3 Option, Complementary Pecl Output
TC-350 Frequency Range = 1MHz - 77.76MHz ;; Output Logic = TTL Hcmos ;; Package = 22.86 X 17.78 X 3.81 ;; Features = Low Profile Smd, 3.3 VDC or 5 VDC
TC-400 Frequency Range = 2.0MHz - 160MHz ;; Output Logic = TTL Hcmos Pecl Sine ;; Package = 20.32 X 12.70 X 10.287 ;; Features = 3.3 VDC or 5 VDC Operation

TRU-050-GBCCA : Frequency Range = 1MHz - 65MHz ;; Output = TTL / CMOS ;; Package (mm) = 20.3 X 7.9 ;; Features = Loop Filter Software Loss of Signal Alarm

VCA1-E6F : 0.8" X 0.5" X 0.2" 14 Pin Dip

VCA3-F4D : 0.8" X 0.5" X 0.4" 14 Pin Dip

VCOB-035A-1G207 :

VCB-2A3F-25M00 : 3.3, 5.0 volt CMOS Oscillator

CDFEER-25M125 : 3.3, 5.0 volt CMOS Oscillator

CO-767PSB38210 : Surface Mount Oven Controlled Crystal Oscillators

CD-700-LAC-GFC-77.760 : Complete VCXO Based Phase Lock Loop

FX-104-CFC-D4N7 : Frequency Translator

FX-104-DFF-A1H9 : Frequency Translator

 
0-C     D-L     M-R     S-Z