Details, datasheet, quote on part number: THS6043ID
PartTHS6043ID
CategorySemiconductors => Amplifiers => Operational Amplifiers (Op Amps) => High-Speed Op Amps (>=50MHz)
Part familyTHS6043 350-mA, +/-12V ADSL CPE Line Driver with Shutdown
TitleLine Drivers and Receivers
Description350-mA, +/-12V ADSL CPE Line Driver with Shutdown 14-SOIC -40 to 85
CompanyTexas Instruments, Inc.
StatusACTIVE
ROHSY
SampleNo
DatasheetDownload THS6043ID datasheet
Quote
Find where to buy
 
Specifications 
Offset Drift(Typ)(uV/C)20
ArchitectureCurrent FB
Iq per channel(Max)(mA)10.5
FeaturesShutdown
BW @ Acl(MHz)120
RatingCatalog
2nd Harmonic(dBc)67
Iq per channel(Typ)(mA)8.2
Input Bias Current(Max)(pA)10000000
CMRR(Typ)(dB)68
Vn at 1kHz(Typ)(nV/rtHz)2.4
Package GroupHTSSOP,SOIC
3rd Harmonic(dBc)96
Vos (Offset Voltage @ 25C)(Max)(mV)16
Total Supply Voltage(Min)(+5V=5, +/-5V=10)9
@ MHz1
Acl, min spec gain(V/V)1
Output Current(Typ)(mA)350
Number of Channels(#)2
Operating Temperature Range(C)-40 to 85,0 to 70
Approx. Price (US$)3.66 | 1ku
CMRR(Min)(dB)59
GBW(Typ)(MHz)120
Total Supply Voltage(Max)(+5V=5, +/-5V=10)33
Slew Rate(Typ)(V/us)1400
Vn at Flatband(Typ)(nV/rtHz)2.2
Rail-to-RailNo
  Mecanical Data
Pin nbPackage typeInd stdJEDEC codePackage qtyCarrierDevice markWidth (mm)Length (mm)Thick (mm)Pitch (mm)
14DSOICR-PDSO-G50TUBETHS6043I 3.918.651.581.27
Application notes
• Active Output Impedance for ADSL Line Drivers
Signal termination is very common in bidirectional communication systems. Termination allows for receiving signals while transmitting different signals at the same time. With the increasing popularity of asymmetrical digital subscriber lines (ADSL), the re | Doc
• Noise Analysis for High Speed Op Amps (Rev. A)
As system bandwidths have increased, an accurate estimate of the noise contribution for each element in the signal channel has become increasingly important. Many designers are not, however, particularly comfortable with the calculations required to predic | Doc
• Wireline Data Transmission and Reception
Many types of wires are widely used to transmit data. Specifically, Category 3 and Category 5 (Cat3 and Cat5e, respectively)—also known as unshielded twisted pair or UTP lines—are now recommended for new telephone installations. Coaxial (coax) cables a | Doc
Evaluation Kits
THS6043EVM: THS6043 Evaluation Module
Spice Model
THS6043 TINA-TI Spice Model (Rev. A) - ZIP (10/06/2011)
THS6043 PSpice Model (Rev. A) - ZIP (10/06/2011)

 

Features, Applications

Ideal for Both Full Rate ADSL and G.Lite Compatible With 1:1 Transformer Ratio Low 2.1 pA/Hz Noninverting Current Noise Reduces Noise Feedback Through Hybrid Into Downstream Channel Wide Supply Voltage Range V Ideal for 12-V Operation Wide Output Swing 43-Vpp Differential Output Voltage, RL 12-V Supply High Output Current 350 mA (typ)

THS6042 SOIC (D) AND SOIC PowerPAD (DDA) PACKAGE (TOP VIEW)

120 MHz (3 dB, V, RL V/s Slew Rate 12 V) Low Distortion, Single-Ended, G dBc (250 kHz, 2 Vpp, 100- load) Low Power Shutdown 300-A Total Standby Current Thermal Shutdown and Short-Circuit Protection Standard SOIC, SOIC PowerPAD and TSSOP PowerPAD Package Evaluation Module Available

THS6043 SOIC (D) AND TSSOP PowerPAD (PWP) PACKAGE (TOP VIEW)
description

The is a high-speed line driver ideal for driving signals from the remote terminal to the central office in asymmetrical digital subscriber line (ADSL) applications. It can operate from a 12-V supply voltage while drawing only mA of supply current per channel. It offers low 79 dBc total harmonic distortion driving a 100- load (2 Vpp). The THS6042/3 offers a high 43-Vpp differential output swing across a 200- load from a 12-V supply. The THS6043 features a low-power shutdown mode, consuming only 300 A quiescent current per channel. The THS6042/3 is packaged in standard SOIC, SOIC PowerPAD, and TSSOP PowerPAD packages.

+12 V VI+ _ THS6042 Driver 750 THS6042 Driver dBm Delivered to Telephone Line DEVICE RELATED PRODUCTS DESCRIPTION

175-mA, 12 ADSL CPE line driver +12 V ADSL CPE line driver +12 V ADSL CPE line driver 5 V Low noise ADSL receiver 5 V Low noise ADSL receiver

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. PowerPAD is a trademark of Texas Instruments.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

AVAILABLE OPTIONS PACKAGED DEVICE 85C SOIC-8 (D) THS6042ID SOIC-8 PowerPAD (DDA) THS6042IDDA SOIC-14 (D) THS6043ID TSSOP-14 (PWP) THS6043CPWP THS6043IPWP EVALUATION MODULES THS6042EVM THS6043EVM

absolute maximum ratings over operating free-air temperature (unless otherwise noted)

Supply voltage, VCC+ to VCC. 33 V Input voltage. VCC Output current (see Note 450 mA Differential input voltage. 4 V Maximum junction temperature. 150C Total power dissipation at (or below) 25C free-air temperature. See Dissipation Ratings Table Operating free-air temperature, TA: Commercial. to 70C Industrial. to 85C Storage temperature, Tstg : Commercial. to 125C Industrial. to 125C Lead temperature mm (1/16 inch) from case for 10 seconds. 300C

Stresses beyond those listed under "absolute maximum ratings" may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated under "recommended operating conditions" is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. NOTE 1: The THS6042 and THS6043 may incorporate a PowerPAD on the underside of the chip. This acts as a heatsink and must be connected to a thermally dissipating plane for proper power dissipation. Failure do so may result in exceeding the maximum junction temperature which could permanently damage the device. See TI Technical Brief SLMA002 for more information about utilizing the PowerPAD thermally enhanced package. DISSIPATION RATING TABLE PACKAGE D-8 DDA D-14 PWP = 150C POWER RATING 1.88 W

3.3 W This data was taken using the JEDEC proposed high-K test PCB. For the JEDEC low-K test PCB, the JA is168C/W for the D8 package and 122.3C/W for the D14 package.

MIN Dual supply Supply voltage voltage, VCC+ to VCC Operating free-air free air temperature, temperature TA Single supply C-suffix I-suffix NOM MAX UNIT V C

electrical characteristics over recommended operating free-air temperature range, = 25C, VCC 12 V, R(FEEDBACK) = 100 (unless otherwise noted)

NOTE 2: Slew rate is defined from the 25% to the 75% output levels.

PARAMETER Total harmonic distortion (single-ended configuration) (RF 390 ) Input voltage noise +Input In Input current noise Input TEST CONDITIONS 100 , VCC = 250 kHz = 4, VCC = 250 kHz VO(pp) 2 V VO(pp) 16 V VO(pp) 2 V VO(pp) 10 kHz = 10 kHz MIN TYP = 2 Vpp, Vpp G dBc nV/Hz pA/Hz dBc MAX UNIT


 

Related products with the same datasheet
THS6043CDR
THS6043CPWP
THS6043CPWPR
THS6043IDR
THS6043IPWP
THS6043IPWPR
THS6043CPWPG4
THS6043CPWPRG4
THS6043IPWPG4
THS6043IPWPRG4
Some Part number from the same manufacture Texas Instruments, Inc.
THS6043IDR ti THS6043, 350-mA, +/-12V Adsl Cpe Line Driver With Shutdown
THS6052
THS6052CD ti THS6052, 175-mA, +/-12V Adsl Cpe Line Driver
THS6053
THS6053CD ti THS6053, 175-mA, +/-12V Adsl Cpe Line Driver With Shutdown
THS6062 Low-noise Adsl Dual Differential Receiver
THS6062CD ti THS6062, Low-noise Adsl Dual Differential Receiver
THS6062D Low-noise Adsl Dual Differential Receiver
THS6062EVM
THS6062ID ti THS6062, Low-noise Adsl Dual Differential Receiver
THS6072 Low-power Adsl Differential Receiver
THS6072CD ti THS6072, Low-power Adsl Differential Receiver
THS6072D Low-power Adsl Differential Receiver
THS6072ID ti THS6072, Low-power Adsl Differential Receiver
THS6092
THS6092CD ti THS6092, 275-mA, +12V Adsl Cpe Line Driver
THS6093
THS6093CD ti THS6093, 275-mA, +12V Adsl Cpe Line Driver With Shutdown
THS6132 High Efficiency Class-g Adsl Line Driver
THS6132RGWR ti THS6132, High Efficiency Class-g Adsl Line Driver
THS6132VFP High Efficiency Class-g Adsl Line Driver

PT3325A :

SN54LS590 :

SN54LVTH573J : 3.3-v Abt Octal Transparent D-type Latches With 3-state Outputs

SN74AHCT540N : Inverting Buffers and Drivers ti SN74AHCT540, Octal Buffers/drivers With 3-State Outputs

UC3525ADWTR : Voltage Mode ti UC3525A, Regulating Pulse Width Modulators

MSP430F2254IRHAT : Mixed Signal Microcontroller

TPS65951A1ZGUR : Integrated Power Management/Audio Codec Silicon The TPS65951 device is a power-management IC for mobile cellular handsets powered by a Li-ion, Li-ion polymer, or cobalt-nickel-manganese cell battery. It can be connected to an application processor and/or a modem. This optimized power-management IC

THS4500IDG4 : IC, DIFF AMP, 370MHZ, 2800V/S, SOIC-8 Specifications: No. of Amplifiers: 1 ; Input Offset Voltage: -7mV ; Gain dB Max: - ; Bandwidth: 370MHz ; Slew Rate: 2800V/s ; Supply Voltage Range: 4.5V to 15V, 5V to 7.5V ; Supply Current: 23mA ; Amplifier Case Style: SOIC ; No. of Pins: 8 ; Operating Temperature Range: -40C to +85C ; MSL: -

TPS72715DSEEVM-406 : 200mA, Ultralow IQ, Fast Transient Response, RF Low-Dropout Linear Regulator The TPS727xx family of low-dropout (LDO) linear regulators are ultralow quiescent current LDOs with excellent line and ultra-fast load transient performance and are designed for power-sensitive applications. The LDO output

CD74HCT175ME4 : HCT SERIES, 9-BIT ENCODER, PDSO16 Specifications: Number of Bits: 9 ; Supply Voltage: 5V ; Package Type: TSSOP, PLASTIC, TSSOP-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 53 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F)

 
0-C     D-L     M-R     S-Z