Details, datasheet, quote on part number: LTC1147I-3.3
PartLTC1147I-3.3
CategoryPower Management => Regulators => Switching Regulators
DescriptionHigh Efficiency Step-down Switching Regulator Controllers
CompanyLinear Technology Corporation
DatasheetDownload LTC1147I-3.3 datasheet
  

 

Features, Applications
LTC1147-3.3 LTC1147-5/LTC1147L High Efficiency Step-Down Switching Regulator Controllers
FEATURES

Very High Efficiency: Over 95% Possible Wide VIN Range: to 16V Current Mode Operation for Excellent Line and Load Transient Response High Efficiency Maintained Over Three Decades of Output Current Low 160µA Standby Current at Light Loads Logic Controlled Micropower Shutdown: < 20µA Short-Circuit Protection Very Low Dropout Operation: 100% Duty Cycle High Efficiency in a Small Amount of Board Space Output Can Be Externally Held High in Shutdown Available 8-Pin SO Package

The LTC®1147 series are step-down switching regulator controllers featuring automatic Burst ModeTM operation to maintain high efficiencies at low output currents. These devices drive an external P-channel power MOSFET at switching frequencies exceeding 400kHz using a constant off-time current mode architecture providing constant ripple current in the inductor. The operating current level is user-programmable via an external current sense resistor. Wide input supply range allows operation from 14V (16V maximum). Constant off-time architecture provides low dropout regulation limited by only the RDS(ON) of the external MOSFET and resistance of the inductor and current sense resistor. The LTC1147 series incorporates automatic power saving Burst Mode operation to reduce switching losses when load currents drop below the level required for continuous operation. Standby power is reduced to only 2mW at VIN = 10V (at IOUT = 0). Load currents in Burst Mode operation are typically to 300mA. For applications where even higher efficiency is required, refer to the LTC1148 data sheet and Application Note 54.

, LTC and LT are registered trademarks of Linear Technology Corporation. Burst Mode is a trademark of Linear Technology Corporation. *LTC1147L and LTC1147L-3.3 only.

Notebook and Palmtop Computers Portable Instruments Battery-Operated Digital Devices Cellular Telephones DC Power Distribution Systems GPS Systems

Operating Ambient Temperature Range to 85°C Extended Commercial Temperature Range (Note to 85°C Junction Temperature (Note 1)............................ 125°C Storage Temperature Range................ to 150°C Lead Temperature (Soldering, 10 sec)................. 300°C

Input Supply Voltage (Pin ­ 0.3V Continuous Output Current (Pin 8)...................... 50mA Sense Voltages (Pins 4, 5) VIN ­ 0.3V VIN < 12.7V............................... (VIN ­ 0.3V

TOP VIEW VIN CT 2 ITH 3 SENSE PDRIVE GND SHDN (VFB*) SENSE +
N8 PACKAGE S8 PACKAGE 8-LEAD PLASTIC DIP 8-LEAD PLASTIC SO * ADJUSTABLE OUTPUT VERSION

SYMBOL V6 I6 VOUT PARAMETER Feedback Voltage (LTC1147L) Feedback Current (LTC1147L) Regulated Output Voltage LTC1147L-3.3 LTC1147-5 Output Voltage Line Regulation Output Voltage Load Regulation LTC1147L-3.3 LTC1147-5 Burst Mode Output Ripple IQ Input DC Supply Current (Note 2) LTC1147 Series Normal Mode Sleep Mode Sleep Mode (LTC1147-5) Shutdown LTC1147L Series Normal Mode Sleep Mode Shutdown (LTC1147L-3.3)

CONDITIONS VIN = 9V VIN = 9V ILOAD = 700mA ILOAD = 700mA VIN to 12V, ILOAD 5mA < ILOAD 5mA < ILOAD < 2A ILOAD = 0A (Note 4V < VIN 4V < VIN 5V < VIN < 12V VSHDN 4V < VIN 3.5V < VIN 3.5V < VIN < 12V VSHDN 3.5V < VIN < 12V

SYMBOL V 4 PARAMETER Current Sense Threshold Voltage (Note I6 I2 tOFF tr, tf SHDN Pin Threshold LTC1147-3.3/LTC1147-5/LTC1147L-3.3 SHDN Pin Input Current LTC1147-3.3/LTC1147-5/LTC1147L-3.3 CT Pin Discharge Current Off-Time (Note 3) Driver Output Transition Times

CONDITIONS VSENSE­ = VOUT + 100mV (Forced) VSENSE­ = VOUT ­ 100mV (Forced) VSENSE­ = VOUT + 100mV (Forced) VSENSE­ = VOUT ­ 100mV (Forced) VSENSE­ + 25mV (Forced) VSENSE­ ­ 25mV (Forced)

SYMBOL V6 VOUT PARAMETER Feedback Voltage (LTC1147L) Regulated Output Voltage LTC1147-3.3/LTC1147L-3.3 LTC1147-5 Input DC Supply Current (Note 2) LTC1147 Series Normal Mode Sleep Mode Sleep Mode (LTC1147-5) Shutdown LTC1147L Series Normal Mode Sleep Mode Shutdown (LTC1147L-3.3) Current Sense Threshold Voltage (Note LTC1147L V6 tOFF SHDN Pin Threshold LTC1147-3.3/LTC1147-5/LTC1147L-3.3 Off-Time (Note 3) CONDITIONS VIN = 9V VIN = 9V ILOAD = 700mA ILOAD = 700mA (Note 4V < VIN 4V < VIN 5V < VIN < 12V VSHDN 4V < VIN 3.5V < VIN 3.5V < VIN < 12V VSHDN 3.5V < VIN < 12V VSENSE ­ = VOUT + 100mV (Forced) VSENSE ­ = VOUT ­ 100mV (Forced) VSENSE ­ = VOUT + 100mV (Forced) VSENSE ­ = VOUT ­ 100mV (Forced) VSENSE­ + 25mV (Forced) VSENSE­ ­ 25mV (Forced) 0V < VSHDN < 8V, VIN = 390pF, ILOAD V µs

The q denotes specifications which apply over the full specified temperature range. Note TJ is calculated from the ambient temperature TA and power dissipation PD according to the following formulas: + (PD)(150°C/W) Note 2: Dynamic supply current is higher due to the gate charge being delivered at the switching frequency. See Applications Information.

Note 3: In applications where RSENSE is placed at ground potential, the offtime increases approximately 40%. Note 4: The LTC1147C is guaranteed to meet specified performance from to 70°C and is designed, characterized and expected to meet these extended temperature limits, but is not tested ­ 40°C and 85°C. The LTC1147I is guaranteed to meet the extended temperature limits. Note 5: The LTC1147L/LTC1147L-3.3 allow operation to VIN = 3.5V. Note 6: The LTC1147L is tested with external feedback resistors resulting in a nominal output voltage of 2.5V.


 

Related products with the same datasheet
LTC1147-3.3
LTC1147-5
LTC11475
LTC1147C-3.3
LTC1147C-5
LTC1147CN8-3.3
LTC1147CN8-5
LTC1147CS8-3.3
LTC1147CS8-5
LTC1147IS8-3.3
LTC1147IS8-5
Some Part number from the same manufacture Linear Technology Corporation
LTC1147IS8-3.3 High Efficiency Step-down Switching Regulator Controllers
LTC1148 High Efficiency Synchronous Step-down Switching Regulators
LTC1148-3.3/5
LTC1148-5
LTC1149 LTC1149, 48V Synchronous Step-down
LTC1150 LTC1150, 15V Zero-drift Operational Amplifier With Internal Capacitors
LTC1151 LTC1151, Dual 15V Zero-drift Operational Amplifier
LTC1151CSW Dual 15V Zero-drift Operational Amplifier
LTC1152 LTC1152, Rail-to-rail Input Rail-to-rail Output Zero-drift op Amp
LTC1152C Rail-to-rail Input Rail-to-rail Output Zero-drift op Amp
LTC1152CN8 LTC1152, Rail-to-rail Input Rail-to-rail Output Zero-drift op Amp
LTC1152I Rail-to-rail Input Rail-to-rail Output Zero-drift op Amp
LTC1152IN8 LTC1152, Rail-to-rail Input Rail-to-rail Output Zero-drift op Amp
LTC1153 LTC1153, Auto-reset Electronic Circuit Breaker
LTC1153IN8 Auto-reset Electronic Circuit Breaker
LTC1154 LTC1154, High-side Micropower MOSFET Driver
LTC1155 LTC1155, Dual High Side Micropower N-Ch. MOSFET Driver With Internal Charge Pump
LTC1155C Dual High Side Micropower MOSFET Driver
LTC1155CJ8 LTC1155, Dual High Side Micropower N-Ch. MOSFET Driver With Internal Charge Pump
LTC1155I Dual High Side Micropower MOSFET Driver
LTC1155IN8 LTC1155, Dual High Side Micropower N-Ch. MOSFET Driver With Internal Charge Pump

LT1172MJ8 : Step-Up and Flyback LT1170, 5A 100kHz, High Efficiency Switching Regulator

LT1790S6-1.25 : Micropower SOT-23 Low Dropout Reference Family

LTC1393C : Single-ended 8-channel/ Differential 4-channel Analog Multiplexer With Smbus Interface

LTC1595 : Current Output LTC1595, 1LSB INL/DNL, Serial 16-Bit Multiplying DACs, SO-8

LTC3805EMSE-TR : Adjustable Frequency Current Mode Flyback/ Boost/sepic Dc/dc Controller

LT1965IDD-TRPBF : 1.1a, Low Noise, Low Dropout Linear Regulator

LTC1403CMSE-1#TR : 12-Bit/14-Bit, 2.8Msps Sampling ADCs With Shutdown.the LTC 1403/LTC1403A Are 12-bit/14-bit, 2.8Msps Serial ADCs With Differential Inputs. The Devices Draw Only 4.7mA From a Single 3V Supply And Come in a Tiny 10-lead MS Package. A Sleep Shutdown Feature Lowers Power Consumption to 10µW. The Co

LTC3250ES6-1.2#TRMPBF : 500ma High Efficiency, Low Noise, Inductorless Step-down Dc/dc Converter

LTC1164-5CN#PBF : Interface - Filter - Active Integrated Circuit (ics) Butterworth or Bessel Lowpass Tube 4.75 V ~ 16 V, ±2.375 V ~ 8 V; IC FILTR 8TH ORDER LOWPASS 14DIP Specifications: Package / Case: 14-DIP (0.300", 7.62mm) ; Filter Type: Butterworth or Bessel Lowpass ; Voltage - Supply: 4.75 V ~ 16 V, ±2.375 V ~ 8 V ; Number of Filters: 1 ; Filter Order: 8th ; Frequency - Cutoff or Center: 20kHz ; Packaging: Tube ; Lead Free Status: Lead Free ; RoHS Status: RoHS

LS-U257-SOIC : SMALL SIGNAL, FET Specifications: Package Type: PLASTIC, DIP-8

LT3837EFE#PBF : SWITCHING CONTROLLER, 110 kHz SWITCHING FREQ-MAX, PDSO16 Specifications: Configuration / Function: SINGLE ; Package Type: Other, 4.40 MM, PLASTIC, TSSOP-16 ; Life Cycle Stage: ACTIVE ; VIN: 14 volts ; fsw: 110 kHz ; Operating Temperature: 0 to 85 C (32 to 185 F)

 
0-C     D-L     M-R     S-Z