Details, datasheet, quote on part number: ISL4260E
PartISL4260E
CategoryAnalog & Mixed-Signal Processing
DescriptionQFN Packaged, 15kV Esd Protected, +3V to +5.5V, 150nA, 250kbps, RS-232 Transmitters/receivers With Separate Logic Supply
CompanyIntersil Corporation
DatasheetDownload ISL4260E datasheet
Quote
Find where to buy
 
  

 

Features, Applications

QFN Packaged, ±15kV ESD Protected, 250kbps, RS-232 Transmitters/Receivers with Separate Logic Supply

The ISL4260E contains to 5.5V powered RS-232 transmitters/receivers which meet ElA/TIA-232 and V.28/V.24 specifications, even at VCC = 3.0V. Targeted applications are PDAs, Palmtops, and cell phones where the low operational, and even lower standby, power consumption is critical. Efficient on-chip charge pumps, coupled with a manual powerdown function reduces the standby supply current a 150nA trickle. Tiny x 5mm Quad Flat NoLead (QFN) packaging, and the use of small, low value capacitors ensure board space savings as well. Data rates greater than 250kbps are guaranteed at worst case load conditions. The ISL4260E features a VL pin that adjusts the logic pin (see Pin Descriptions table) output levels and input thresholds to values compatible with the VCC powering the external logic (e.g., a UART). The single pin powerdown function (SHDN = 0) disables all the receiver and transmitter outputs, while shutting down the charge pump to minimize supply current drain. Table 1 summarizes the features of the ISL4260E, while Application Note AN9863 summarizes the features of each device comprising the 3V RS-232 family.

Features

Available in Near Chip Scale QFN (5mmx5mm) Package VL Pin for Compatibility with Mixed Voltage Systems ESD Protection for RS-232 I/O Pins ±15kV (IEC61000) Single SHDN Pin Disables Transmitters and Receivers Meets EIA/TIA-232 and V.28/V.24 Specifications at 3V On-Chip Charge Pumps Require Only Four External 0.1µF Capacitors Receiver Hysteresis For Improved Noise Immunity Very Low Supply Current. 300µA Guaranteed Minimum Data Rate. 250kbps Wide Power Supply Range. Single to +5.5V Low Supply Current in Powerdown State.150nA

Applications

Any System Requiring RS-232 Communication Ports - Battery Powered, Hand-Held, and Portable Equipment - Laptop Computers, Notebooks, Palmtops - Digital Cameras - PDAs and PDA Cradles - Cellular/Mobile Phones

PART NUMBER ISL4260EIR ISL4260EIR-T TEMP. RANGE (oC) to 85 PACKAGE 32 Lead QFN 32 Lead QFN Tape & Reel PKG. NO. L32.5x5

TABLE 1. SUMMARY OF FEATURES PART NUMBER ISL4260E NO. OF NO. OF DATA RATE Rx. ENABLE Tx. Rx. (kbps) FUNCTION? NO VL LOGIC SUPPLY PIN? YES MANUAL AUTOMATIC POWER- DOWN? POWERDOWN FUNCTION? YES NO

CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc. Copyright © Intersil Americas Inc. 2003. All Rights Reserved

PIN VCC V+ VGND C1C2+ C2TIN TOUT RIN ROUT VL SHDN NC System power supply input to 5.5V). Internally generated positive transmitter supply (+5.5V). Internally generated negative transmitter supply (-5.5V). Ground connection. External capacitor (voltage doubler) is connected to this lead. External capacitor (voltage doubler) is connected to this lead. External capacitor (voltage inverter) is connected to this lead. External capacitor (voltage inverter) is connected to this lead. TTL/CMOS compatible transmitter Inputs. The switching point is a function of the VL voltage. ±15kV ESD Protected, RS-232 level (nominally ±5.5V) transmitter outputs. ±15kV ESD Protected, RS-232 compatible receiver inputs. TTL/CMOS level receiver outputs. Swings between GND and VL. Logic-Level Supply. All TTL/CMOS inputs and outputs are powered by this supply. Active low TTL/CMOS input to tri-state receiver and transmitter outputs and to shut down the on-board power supply to place device in low power mode. The switching point is a function of the VL voltage. No Connection FUNCTION


 

Related products with the same datasheet
ISL4260EIR
ISL4260EIR-T
Some Part number from the same manufacture Intersil Corporation
ISL4260EIR QFN Packaged, 15kV Esd Protected, +3V to +5.5V, 150nA, 250kbps, RS-232 Transmitters/receivers With Separate Logic Supply
ISL4270E QFN Packaged, +/-15kV Esd Protected, +3V to +5.5V, 300nA, 250kbps, RS-232 Transceivers With Enhanced Automatic Powerdown And a Separate Logic Supply
ISL43110 Low-Voltage, Single Supply, Spst, High Performance Analog Switches
ISL43112 Low-Voltage, Dual Supply, Spst, High Performance Analog Switches
ISL43120 Low-Voltage, Single Supply, Dual Spst, SPDT Analog Switches
ISL43140 Low-Voltage, Single And Dual Supply, High Performance, Quad Spst, Analog Switches
ISL43143 Low-Voltage, Single And Dual Supply, Quad Spst, High Performance Analog Switches
ISL43210 Low-Voltage, Single Supply, Dual Spst, SPDT Analog Switches
ISL43231 Low-voltage, Single And Dual Supply, Triple SPDT Analog Switch
ISL43240 Low-Voltage, Single And Dual Supply, Quad Spdt, Analog Switches
ISL43410 Low-Voltage, Single Supply, DPDT High Performance Analog Switch
ISL43485 3.3V, Low Power, 30Mbps, RS-485/RS-422 Transceiver
ISL43640 Low-Voltage, Single Supply, 4 to 1 Multiplexer, High Performance Analog Switch
ISL43681 Low-voltage, Single And Dual Supply, 8 to 1 Multiplexer And Differential 4 to 1 Multiplexer
ISL43741
ISL43840 Low-voltage, Single And Dual Supply, Dual 4 to 1 Multiplexer Analog Switch With Enable
ISL43841
ISL43L120 Ultra Low ON-Resistance, Single Supply, Dual SPST Analog Switches<<<>>>the Intersil ISL43L120, ISL43L121, ISL43L122 Devices Are Low ON-resistance, Low Voltage, Bidirectional, Precision, Dual Single-pole/single-throw

EL8201IS-T7 : op Amp, Dual, 200MHz, Rail-to-rail With Enable The EL8200, EL8201, And EL8401 Represent Rail-to-rail Amplifiers With a -3dB Bandwidth of 200MHz And Slew Rate of 200V/µs. Running Off a Very Low Supply Current of 2mA Per Channel, The EL8200, EL8201, And EL8401 Also Feature Inputs That go

ICM7243BIJL : 8-character, Microprocessor- Compatible, Led Display Decoder Driver

ISL84543IP : Low-Voltage, Single Supply, Dual Spst, SPDT Analog Switches

RFD14N05 : 14a, 50v, 0.100 Ohms, N-channel Power MOSFETs

ISL21007CFB830Z-TK : Precision, Low Noise FGA?? Voltage References The ISL21007 FGA?? voltage references are extremely low power, high precision, and low noise voltage references fabricated on Intersil’s proprietary Floating Gate Analog technology. The ISL21007 features very low noise (4.5?VP-P for 0.1Hz to 10Hz) and v

ISL54206IRUZ-T : Low Voltage, Dual Spdt, Usb/cvbs/ Audio Switches, with Negative Signal Capability

HI2-0200/883 : Dual SPST CMOS Analog Switch

EL5292_07 : Dual 600mhz Current Feedback Amplifier with Enable

ISL8841AMBEPZ-TK : SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, PDSO8 Specifications: Configuration / Function: PUSH-PULL ; Package Type: SOIC, Other, ROHS COMPLIANT, PLASTIC, MS-012AA, SOIC-8 ; Life Cycle Stage: ACTIVE ; VIN: 15 volts ; fsw: 2000 kHz ; Operating Temperature: -55 to 125 C (-67 to 257 F)

5962R9674202TEX : 4000/14000/40000 SERIES, DUAL MONOSTABLE MULTIVIBRATOR, CDFP16 Specifications: Supply Voltage: 5V ; Features: Complementary Output ; Package Type: Other, CERAMIC, FP-16 ; Logic Family: CMOS ; Number of Pins: 16 ; Propagation Delay: 810 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F)

Same catergory

AH0014 : DPST/DPDT. Dual Dpst-ttl/dtl Compatible MOS Analog Switch (discontinued).

GS9025 : Genlinx(tm)ii Serial Digital Receiver. PRELIMINARY DATA SHEET SMPTE 259M compliant operational to 540Mb/s automatic cable equalization (typically greater than 350m of high quality cable at 270Mb/s) adjustment-free operation auto-rate selection (5 rates) with manual override single external VCO resistor for operation with five input data rates data rate indication output system friendly:.

ISL43140 : Low-Voltage, Single And Dual Supply, High Performance, Quad Spst, Analog Switches.

LC7980 : Controller For LCD Dot Matrix Graphic Display.

LH0021 : 1.0 Amp Power Operational Amplifier (discontinued).

LMC6084ALM : Precision CMOS Quad Operational Amplifier. The is a precision quad low offset voltage operational amplifier, capable of single supply operation. Performance characteristics include ultra low input bias current, high voltage gain, rail-to-rail output swing, and an input common mode voltage range that includes ground. These , plus its low offset voltage, make the LMC6084 ideally suited for precision.

LPV321 : LPV321 - General Purpose, Low Voltage, Low Power, Rail-to-rail Output Operational Amplifiers, Package: SOT-23, Pin Nb=5.

NJM2082 : Dual J-FET Input Operational Amplifier.

TLV2344Y : Lincmose Low-voltage High-speed Operational Amplifiers. Wide Range of Supply Voltages Over Specified Temperature Range: 8 V Fully Characterized 3 V and 5 V Single-Supply Operation Common-Mode Input-Voltage Range Extends Below the Negative Rail and Up to VDD at 25°C Output Voltage Range Includes Negative Rail High Input Impedance. 1012 Typical ESD-Protection Circuitry Designed-In Latch-Up Immunity The TLV234x.

UPC4062 : Dual J-FET Input Low-power Operational Amplifier.

ZM33164-3 : Power. Supply Voltage Monitor. The is a three terminal under t fo microprocessor systems. The threshold voltage of the device has been set to 2.68 volts making it ideal for 3 volt circuits. Included in the device is a precise voltage reference and a comparator with built in hysteresis to prevent erratic operation. The ZM33164-3 an open collector output capable of sinking at least.

AP393N : Comparators. Wide supply Voltage range: to 36V Single or dual supplies: to ±18V Very low supply current drain (0.4mA) ­ independent of supply voltage Low input biasing current: 25nA Low input offset current: ±5nA Maximum offset voltage: ±3mV Input common-mode voltage range includes ground Differential input voltage range equal to the power supply voltage Low output.

MCP4131 : 7/8-Bit Single/Dual SPI Digital POT With Volatile Memory The MCP41/42XX devices are non-volatile, 7-bit (129 wiper steps) digital potentiometers that are programmed/reprogrammed through an SPI compatible interface. The MCP41/42XX devices offer a variety of configurations simplifying design while minimizing cost, package size and pin count. The MCP41/42XX.

MAX4465 : Low-Cost, Micropower, SC70/SOT23-8, Microphone Preamplifiers With Complete Shutdown The MAX4465–MAX4469 are micropower op amps optimized for use as microphone preamplifiers. They provide the ideal combination of an optimized gain bandwidth product vs. supply current, and low-voltage operation in an ultra-small package. The MAX4465/MAX4467/MAX4469 are unity-gain.

 
0-C     D-L     M-R     S-Z