Details, datasheet, quote on part number: ISL4223EIR-T
PartISL4223EIR-T
CategoryAnalog & Mixed-Signal Processing
DescriptionQFN Packaged, +/-15kV Esd Protected, +2.7V to +5.5V, 150Nanoamp, 250kBps, RS-232 Transmitters/receivers
CompanyIntersil Corporation
DatasheetDownload ISL4223EIR-T datasheet
Quote
Find where to buy
 
  

 

Features, Applications

The Intersil ISL422XE devices are to 5.5V powered RS-232 transmitters/receivers which meet ElA/TIA-232 and V.28/V.24 specifications, even at VCC = 3.0V. Additionally, they provide 15kV ESD protection (IEC61000-4-2 Air Gap, and Human Body Model) on transmitter outputs and receiver inputs (RS-232 pins). Targeted applications are PDAs, Palmtops, and hand-held products where the low operational, and even lower standby, power consumption is critical. Efficient on-chip charge pumps, coupled with manual and automatic powerdown functions, reduce the standby supply current a 150nA trickle. Tiny x 5mm Quad Flat No-Lead (QFN) packaging and the use of small, low value capacitors ensure board space savings as well. Data rates greater than 250kBps are guaranteed at worst case load conditions. The a 1 driver, 1 receiver device and the a 2 driver, 2 receiver device that, coupled with the 5x5 QFN package, provide the industry's smallest, lowest power serial port suitable for PDAs, and hand-held applications. The 5x5 QFN requires 40% less board area than a 20 lead TSSOP, and is nearly 20% thinner. The ISL422XE features an automatic powerdown function that powers down the on-chip power-supply and driver circuits. This occurs when an attached peripheral device is shut off or the RS-232 cable is removed, conserving system power automatically without changes to the hardware or operating system. It powers up again when a valid RS-232 voltage is applied to any receiver input. Table 1 summarizes the features of the ISL422XE, while Application Note AN9863 summarizes the features of each device comprising the 3V RS-232 family.

PART NUMBER ISL4221E ISL4223E NO. OF NO. OF Tx. Rx. QFN PKG. AVAILABLE? YES DATA RATE (kBps) 250
Features

Available in Near Chip Scale QFN (5mmx5mm) Package which is 40% Smaller than a 20 Lead TSSOP ESD Protection for RS-232 I/O Pins 15kV (IEC61000) Meets EIA/TIA-232 and V.28/V.24 Specifications 3V RS-232 Compatible with VCC = 2.7V On-Chip Voltage Converters Require Only Four External 0.1F Capacitors Manual and Automatic Powerdown Features Receiver Hysteresis For Improved Noise Immunity Guaranteed Minimum Data Rate. 250kBps Wide Power Supply Range. Single to +5.5V Low Supply Current in Powerdown State.150nA

Applications

Any Space Constrained System Requiring RS-232 Ports - Battery Powered, and Portable Equipment - Hand-Held Products (GPS Receivers, Bar Code Scanners, etc.) - PDAs and Palmtops, Data Cables - Cellular/Mobile Phones, Digital Cameras

Technical Brief TB363 "Guidelines for Handling and Processing Moisture Sensitive Surface Mount Devices "Technical Brief TB379 "Thermal Characterization of Packages for ICs" Technical Brief TB389 "PCB Land Pattern Design and Surface Mount Guidelines for QFN Packages"

TABLE 1. SUMMARY OF FEATURES Rx. ENABLE FUNCTION? YES MANUAL POWERDOWN? YES AUTOMATIC POWERDOWN FUNCTION? YES

PART NO. ISL4223EIR ISL4223EIR-T TEMP. RANGE (oC) to 85 PACKAGE 16 Ld QFN 16 Ld QFN Tape & Reel 20 Ld QFN 20 Ld QFN Tape & Reel PKG. NO. L16.5x5 L20.5x5

CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2003. All Rights Reserved

PIN VCC V+ VGND C1C2+ C2TIN TOUT RIN ROUT INVALID System power supply input to 5.5V). Internally generated positive transmitter supply (+5.5V). Internally generated negative transmitter supply (-5.5V). Ground connection. External capacitor (voltage doubler) is connected to this lead. External capacitor (voltage doubler) is connected to this lead. External capacitor (voltage inverter) is connected to this lead. External capacitor (voltage inverter) is connected to this lead. TTL/CMOS compatible transmitter Inputs. 15kV ESD Protected, RS-232 level (nominally 5.5V) transmitter outputs. 15kV ESD Protected, RS-232 compatible receiver inputs. TTL/CMOS level receiver outputs. Active low output that indicates if no valid RS-232 levels are present on any receiver input. FUNCTION

FORCEOFF Active low to shut down transmitters and on-chip power supply. This overrides any automatic circuitry and FORCEON (see Table 2). FORCEON EN Active high input to override automatic powerdown circuitry thereby keeping transmitters active. (FORCEOFF must be high). Active low receiver enable control.



 

Related products with the same datasheet
ISL4221EIR
ISL4221EIR-T
ISL4223E
ISL4223EIR
Some Part number from the same manufacture Intersil Corporation
ISL4238E QFN Packaged, 15kV Esd Protected, +2.7V to +5.5V, 10Nanoamp, 250kbps/ 1Mbps, RS-232 Transceivers With Enhanced Automatic Powerdown
ISL4241E QFN Packaged, +/-15kV Esd Protected, +2.7V to +5.5V, 10Nanoamp, 250kbps, RS-232 Transmitters/receivers
ISL4244E QFN Packaged, 15kV Esd Protected, +2.7V to +5.5V, 10Nanoamp, 250kbps/ 1Mbps, RS-232 Transceivers With Enhanced Automatic Powerdown
ISL4260E QFN Packaged, 15kV Esd Protected, +3V to +5.5V, 150nA, 250kbps, RS-232 Transmitters/receivers With Separate Logic Supply
ISL4270E QFN Packaged, +/-15kV Esd Protected, +3V to +5.5V, 300nA, 250kbps, RS-232 Transceivers With Enhanced Automatic Powerdown And a Separate Logic Supply
ISL43110 Low-Voltage, Single Supply, Spst, High Performance Analog Switches
ISL43112 Low-Voltage, Dual Supply, Spst, High Performance Analog Switches
ISL43120 Low-Voltage, Single Supply, Dual Spst, SPDT Analog Switches
ISL43140 Low-Voltage, Single And Dual Supply, High Performance, Quad Spst, Analog Switches
ISL43143 Low-Voltage, Single And Dual Supply, Quad Spst, High Performance Analog Switches
ISL43210 Low-Voltage, Single Supply, Dual Spst, SPDT Analog Switches
ISL43231 Low-voltage, Single And Dual Supply, Triple SPDT Analog Switch
ISL43240 Low-Voltage, Single And Dual Supply, Quad Spdt, Analog Switches
ISL43410 Low-Voltage, Single Supply, DPDT High Performance Analog Switch
ISL43485 3.3V, Low Power, 30Mbps, RS-485/RS-422 Transceiver
ISL43640 Low-Voltage, Single Supply, 4 to 1 Multiplexer, High Performance Analog Switch
ISL43681 Low-voltage, Single And Dual Supply, 8 to 1 Multiplexer And Differential 4 to 1 Multiplexer

5962F9860201VXC : Radiation Hardened Hex Inverter With Open Drain Outputs

FSYE923A0R3 : Radiation Hardened, Segr Resistant P-channel Power MOSFETs

ISL3175EIUZ : 15kV ESD Protected, 3.3V, Full Fail-safe, Low Power, High Speed or Slew Rate Limited, RS-485/RS-422 Transceivers The Intersil ISL317XE are 15kV IEC61000 ESD Protected, 3.3V powered, single transceivers that meet both the RS-485 and RS-422 standards for balanced communication. These devices have

ISL29000IROZ-T7 : Integrated Digital Ambient Light Sensor with Interrupt Function

EL6839CLZT13 : Dual 4-channel Driver with Oscillator and LVDS

X5043V : CPU Supervisor with 4K SPI Eeprom

ISL6566AIRZ : Three-phase Buck PWM Controller with Integrated Mosfet Drivers for Vrm9, Vrm10, and AMD Hammer Applications

ISL21080CIH325Z-TK : 300na Nanopower Voltage References

ISL59112IEZ-T7 : Triple Channel Video Driver with LPF

X28C512PI : 5V, Byte Alterable Eeprom

ISL9000IRKPZ-T : Dual LDO with Low Noise, Very High Psrr, and Low IQ

CD14538BNSRE4 : 4000/14000/40000 SERIES, DUAL MONOSTABLE MULTIVIBRATOR, UUC15 Specifications: Supply Voltage: 5V ; Features: Complementary Output ; Package Type: Other, DIE-15 ; Logic Family: CMOS ; Number of Pins: 15 ; Propagation Delay: 810 ns ; Operating Temperature: -55 to 125 C (-67 to 257 F)

 
0-C     D-L     M-R     S-Z