Details, datasheet, quote on part number: SLE66CX1360PE
CategoryCommunication => Security & Smart Card
DescriptionSecurity & Chip Card Ics
CompanyInfineon Technologies Corporation
DatasheetDownload SLE66CX1360PE datasheet
Find where to buy


Features, Applications

8/16-Bit Security Controller with enhanced instruction set for large memories 0.22 m CMOS Technology 308 Kbytes ROM, 7100 bytes RAM, 136-Kbytes EEPROM 1100-Bit Advanced Crypto Engine

This document contains preliminary information on a new product under development. Details are subject to change without notice. Revision History: Page Current Version 02.04 Previous Releases:03.03

Important: Further information is confidential and on request. Please contact: Infineon Technologies AG in Munich, Germany, Security & Chip Card ICs, Tel Fax E-Mail:

Edition 2004 Published by Infineon Technologies AG, CC Applications Group St.-Martin-Strasse 53, D-81541 Mnchen Infineon Technologies AG 2002 All Rights Reserved. Attention please! The information herein is given to describe certain components and shall not be considered as warranted characteristics. Terms of delivery and rights to technical change reserved. We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding circuits, descriptions and charts stated herein. Infineon Technologies is an approved CECC manufacturer. Information For further information on technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies Office in Germany or our Infineon Technologies Representatives world-wide (see address list). Warnings Due to technical requirements components may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies Office. Infineon Technologies Components may only be used in life-support devices or systems with the express written approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support devices or systems are intended to be implanted in the human body, or to support and/or maintain and sustain and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may be endangered.

SLE 66CX1360PE 8/16-Bit Security Controller with enhanced instruction set for large memories in 0.22m CMOS Technology 308 Kbyte ROM, 7100 bytes RAM, 136-Kbyte EEPROM 1100-Bit ACE and Dual Key Triple DES Accelerator


8/16-bit microcomputer 0.22 m CMOS technology Instruction set opcode compatible with standard SAB 8051 processor Downward compatibility to existing SLE 66CxxxP products for existing masks (without using the new features) Addressable memory to 16 Mbyte Additional enhanced instructions for direct physical memory access of >64kByte

Internal Clock with to 33 MHz: Programmable internal frequency (PLL x3, x4 and free running mode(s)). Adjustable internal frequency according to available power or required performance

Increased internal frequency for maximum performance Internal frequency is automatically adjusted to guarantee a given limited power consumption

Two 16-bit Autoreload Timer Power saving sleep mode Ext. Clock freq. to 7.5 MHz UART for handling serial interface in accordance with ISO/IEC 7816 part 3 supporting transmission protocols T=1 and T=0 Supply voltage 5.0 V Support of current consumption limits by GSM / UICC applications 1.98 V Operating Temperature range: to +85C Storing temperature range: to +125C ESD protection larger than 6 kV (HBM)

Typically saves 90 % code space and increases execution speed to 80%.

Dedicated, non-standard architecture with execution time 6 times faster than standard SAB 8051 processor at same external clock. (Up to 18 times faster using internal frequency PLL x 3 compared to external clock). 308 Kbytes User ROM for application programs 136 Kbytes MicroSlim-EEPROM for increased memory requirements in mobile applications 6 Kbytes XRAM, 256 bytes internal RAM, 700 bytes Crypto RAM. Enhanced Memory Management and Protection Unit (MMU) with application and user defined segments Dual Key Triple DES (DDES) Advanced Crypto Engine:

MicroSlim-EEPROM Typical Erase + Write time 2.9 ms Enhanced ECC module controlled by OS Reading and programming byte by byte Platform prepared for flash-like erasing of E-segments 2 kB Flexible page mode for to 64 bytes write/erase operation 32 bytes security area (OTP) Fast personalization mode 1.0 ms Minimum of 500.000 write/erase cycles @ 25C per page. Maximum of 16.500.000 write/erase cycles per sector Typical data retention 10 years @ 25C

to 1100 bit RSA calculation in Hardware to 2048 bit RSA calculation via fast and secure RSA 2048 crypto library (CC EAL 5+ certified within SLE66CX322P, refer to product brief) Supports Elliptic Curves over GF[p]

CC EAL5+ certification according to BSI-PP-0002 planned True Random Number Generator with Firmware test function CRC Module 16-bit Interrupt Module Code executions during E-programming for faster personalization EEPROM programming voltage generated on chip


Some Part number from the same manufacture Infineon Technologies Corporation
SLE66CX160P Security & Chip Card Ics
SLE66CX320P Chipcard Security Controller
SLE66CX322P Security & Chip Card Ics
SLE66CX640P Chipcard Security Controller
SLE66CX642P Security & Chip Card Ics
SLE66R35 Secure Mobile Solutions
SLE7736 Security & Chip Card Ics
SLG2016 X/y Stackable.180 4-character 5x7 Dot Matrix Alphanumeric Intelligent Display With Memory/decoder/driver
SLX24C01 1/2 KB Serial CMOS EePROMs, I*2c Synchronous 2-wire Bus: 128/256x8
SLX24C01/P 1kb Serial CMOS EePROMs, I2c Synchronous 2-wire Bus, Page Protection Mode(tm): 128x8

DLR5735 : 5x7 Dot Matrix (red)

HYB25D256400BT-8 : 256Mbit Double Data Rate (DDR) Components

LOPT672-KN : Super Multi Toplead(r) High-current Led

LY3341-M : Green Led

SGB15N60HS : 1200V HighSpeed2 And 600V Highspeed Igbt For Switching Frequency From 30kHz Upwards. Focus Applications: Lamp Ballast, Power Supplies For Industry & Consumer Applications

V23870-A2111-A100 : Bi-directional Pigtail SFF Transceiver 155 Mb/s, 1310 NM TX / 1310 NM RX

Q67042-S4403 : Cool MOS Power Transistor

BG5130R : DUAL - N-channel Mosfet Tetrode

HYB25D128160TGL-7F : Memory Spectrum

HYB18T256160TE-75 : Memory Spectrum

TLE4263GS : Pmic - Voltage Regulator - Linear (ldo) Integrated Circuit (ics); IC REG LDO 5V 250MA DSO-8 Specifications: Lead Free Status: Lead Free ; RoHS Status: RoHS Compliant


Same catergory

ACT7005 : Act7005/7006 Single Package Solution Dual Transceiver, Protocol, Subsystem.

CD74HC4316 : High-speed CMOS Logic Quad Analog Switch With Level Translation. Data sheet acquired from Harris Semiconductor SCHS212B High-Speed CMOS Logic Quad Analog Switch with Level Translation The 'HC4316 and CD74HCT4316 contain four independent digitally controlled analog switches that use silicon-gate CMOS technology to achieve operating speeds similar to LSTTL with the low power consumption of standard CMOS integrated.

FU-645PDF-V1M1B : 1.55 um Uncooled Dfb-ld Module With Singlemode Fiber Pigtail ( Bias Circuit Integrated, Digital Application ).

HCPL-553X : Hermetically Sealed, Transistor Output Optocouplers For Analog And Digital Applications.

LSIFC929 : Pci-x to Dual-channel Fibre Channel Solutionsthe LSIFC929X Controller Offers Industry-leading Performance at an Affordable Price. The LSIFC929X Controller Includes Three Embedded Arm Processors And Advanced Performance , Such as Adaptive Interrupt Coalescing And Native PCI-X. The LSIFC929X is a True Multifunctional Device Supporting Fibre Channel Protocol.


M67748HR : RF Power Module For 150-175MHz, 12.5V, 7W FM Portable Radio.

MC54-74HC244A : Octal 3-state Noninverting Buffer/line Driver/line Receiver. Octal 3-State Noninverting Buffer/Line Driver/ Line Receiver The MC54/74HC244A is identical in pinout to the LS244. The device inputs are compatible with standard CMOS outputs; with pullup resistors, they are compatible with LSTTL outputs. This octal noninverting buffer/line driver/line receiver is designed to be used with 3state memory address drivers,.

MT9079AE : = Advanced Controller For E1 ;; Package Type = Pdip ;; No. Of Pins = 40.

PIT-2601 : Isdn u Interface Transformer For At&t T7234.

S558-5999-36 : LAN Magnetic. XFMR Module, 10/100Base-TX. Meets all IEEE 802.3 standards including 350H with 8mA bias Operating temperature 70 C Low profile, surface mount packaging rated 225 C peak IR reflow temperature Designed for use with a variety of 10/100 transceiver ICs Minimum interwinding breakdown voltage of 1500 Vrms Insertion Loss dB max Return Loss dB min Common to Differential Mode Rejection.

SAB82532H-10 : Enhanced Serial Communication Controller (2 Channels). Current Version: 07.96 Subjects (major changes since last revision) new package provided: P-MQFP-80 Selectable out-of-band flow control in ASYNC mode: added In-band flow control transparency: added Selectable enhanced resolution BRG: added RSTA register, ISR0 register (RME interrupt): extended Timer register (TIMR): extended for V3.x XBCH, bit XC: extended.

SN68090 : Speech Controller. a 90 seconds single chip voice synthesizer IC which contains I/O pins and a tiny controller. By programming through the tiny controller, user's applications including section combination, trigger modes, output status, and other logic functions can then be easily implemented. Single power supply - 5.1V Built in a tiny controller 90 seconds voice capacity.

TA1216AN : Tv-audio Processor ic.

W91F812AN : 23-flash Memory Tone/pulse Dialer With Handfree, Lock And Hold Functions.

XRT72L58 : Eight-channel DS3/E3 Framer ic. EIGHT CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER The XRT72L58 Octal DS3/E3 Framer is designed to accept "User Data" from the Terminal Equipment and insert this data into the "payload" bit-fields within an "outbound" DS3/E3 Data Stream. Further, the Framer is also designed to receive an "inbound" DS3/E3 Data Stream (from the Remote Terminal Equipment).

TDA8025 : IC Card Interface The TDA8025 is a cost-effective analog interface for asynchronous smart cards operating at 3 V, 1.8 V or optionally, 1.2 V. Using few external components, the TDA8025 provides integrated supply, protection and control functions for a range of applications..

0-C     D-L     M-R     S-Z