|Category||Power Management => DC-DC Converters|
|Description||3 Watt Regulated Wide Input Range DC/DC Converter|
|Company||C&D Technologies (NCL)|
|Datasheet||Download WPC03R12D05L datasheet
|Related products with the same datasheet|
|Some Part number from the same manufacture C&D Technologies (NCL)|
|WPC03R12D12E 3 Watt Regulated Wide Input Range DC/DC Converter|
|WPC10R 10 Watt Regulated DC/DC Converter. 2:1 Input Range. Industry Standard Pinout. 1,500 VDC Rated ISOlation. Single And Dual Outputs.|
|WPC10R24D05FR 2:1 Wide Input Range DC/DC Converter|
18473 : Axial Lead Inductors
26S681 : Surface Mount Inductors
41151 : Toroidal Surface Mount Inductors
78604/1M-R : Pulse Transformer, With SMD Option
HL02U12S15Y : 2 Watts Unregulated DC/DC Converter
HPR1014 : 1.0 Watt Unregulated Sip DC/DC Converter
NMV2415DA : 3kVDC ISOlated 1W Single And Dual Output DC/DC Converters
NPH15S4815EI : ISOlated 15W Single Output DC/DC Converters
VKA100LS05 : 100 Watt Single Output High Density DC/DC Converter
VKA100MS15 : 100 Watt Single Output High Density DC/DC Converter
AN7710 : Fixed. Low-dropout Three-pin Voltage Regulator 1.2-a Type. The AN7700, AN7700F, and AN7700SP series are stabilized constant-voltage power supplies with small difference between I/O voltages (0.5 V typ.). They are suitable for low-voltage, battery-driven equipment, and home appliances and industrial equipment with great fluctuation of the supply voltage. The output voltage ranges: For 20 V, and 24 V For 12 V, and V AN7700.
CQ2001-7R : 60132 Watt DC-DC Converters. Input voltage ranges or 2 isolated outputs kV AC I/O electric strengh test voltage Extremely slim case (4TE wide), fully enclosed Extremely low inrush current, hot swappable Operating ambient temperaturerange 4071 °C with convection cooling Options Options Input voltage Inrush current ETS 300 132-2 refer to selection chart typ. 40 A Efficiency Output.
CS5156GD16 : Controllers. Cpu 5-Bit Nonsynchronous Buck Controller , Package: Soic, Pins=16.
HCF4016BC1 : Quad Bilateral Switch. 20V DIGITAL ± 10V PEAK-TO-PEAK SWITCHING 280 TYPICAL ON RESISTANCE FOR 15V OPERATION SWITCH ON RESISTANCE MATCHED TO WITHIN 10 TYP. OVER 15V SIGNAL INPUT RANGE HIGH ON/OFF OUTPUT-VOLTAGE RATIO : 65dB TYP. @ fis = 10k HIGH DEGREE OF LINEARITY < 0.5% DISTORTION TYP. @ fis = 1KHz, Vis = 5 Vpp, VDD VSS = 10k EXTREMELY LOW OFF SWITCH LEAKAGE RESULTING.
IR3220S : Fully Protected H-bridge For DC Motor in a 20 Lead Soic Package. The is a fully protected dual high side switch I.C that integrates an Hbridge motor controller with two very efficient high side MOSFETs in a single 20-pin package. The IR3220S combines with the two low side IRF7484Q MOSFETs as few as 10 external passive components to provide a complete, fully operational and fully protected H-bridge control actuator.
LTC1422 : LTC1422, 3V to 12V, SO-8. Allows Safe Board Insertion and Removal from a Live Backplane System Reset Output with Programmable Delay Programmable Electronic Circuit Breaker User-Programmable Supply Voltage Power-Up Rate High Side Driver for an External N-Channel FET Controls Supply Voltages from to 12V Undervoltage Lockout Soft Reset Input Glitch Filter on RESET Available in 8-Pin.
MAX1507 : MAX1507 Linear Li+ Battery Charger With Integrated Pass Fet And Thermal Regulation in a 3mm X 3mm Thin DFN.
NCP1402SN19T1 : Converters. up to 200mA, 1.9V, Boost PFM Switching Regulator With Enable, Package: SOT-23 / TSOP-5, Pins=5.
P8SG-0505ZH30M : Power/w = 1,5 ;; Input/vdc = 5/12/24 ;; Output/vdc = +/-3,6/5/7,2/12/15/18 Regulated ;; ISOlation = 3000V ;; Package = DIP24M.
TDD40-03S2 : DC-DC Converter 40Watt. LOW COST 2:1 AND 3:1 WIDE INPUT RANGE I/O ISOLATION INPUT Pi FILTER SHORT CIRCUIT PROTECTION HIGH PERFORMANCE 2 YEARS WARRANTY OUTPUT WATTAGE VOLTAGE Single Output Models Block diagram for TDD40 series with single output Vi + Switching Device Vi Opto Isolation Reference & Error Amp. Rectifier Block diagram for TDD40 series with dual output Vi + Rectifier.
TL3845Y : Current-mode PWM Controllers. Optimized for Off-Line and dc-to-dc Converters Low Start-Up Current (<1 mA) Automatic Feed-Forward Compensation Pulse-by-Pulse Current Limiting Enhanced Load-Response Characteristics Undervoltage Lockout With Hysteresis Double-Pulse Suppression High-Current Totem-Pole Output Internally Trimmed Bandgap Reference 500-kHz Operation Error Amplifier With.
TPS70345PWP : ti TPS70345, Dual-output Low-dropout (LDO) Voltage Regulators. TPS70358, TPS70302 DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS Applications Selectable Power Up Sequencing for DSP Applications (See TPS704xx for Independent Enabling of Each Output) Output Current Range A on Regulator 1 and A on Regulator 2 Fast Transient Response Voltage Options Are 3.3-V/1.5-V,.
TPS73618DBVR : ti TPS73618, Cap-Free, NMOS, 400mA Low Dropout Regulator With Reverse Current Protection.
TPS77025DBV : Ultra Low-power 50-ma Low-dropout Linear Regulators. 50-mA Low-Dropout Regulator Available 3.0-V, 3.3-V, and 5-V Fixed-Output and Adjustable Versions Only 17 µA Quiescent Current 1 µA Quiescent Current in Standby Mode Dropout Voltage Typically @ 50mA Over Current Limitation to 125°C Operating Junction Temperature Range 5-Pin SOT-23 (DBV) Package The TPS770xx family of low-dropout (LDO) voltage regulators.
TPS731125 : The TPS731xx family of low-dropout (LDO) linear voltage regulators uses a new topology: an NMOS pass element in a voltage-follower configuration. This topology is stable using output capacitors with low ESR, and even allows operation without a capacitor. It also provides high reverse blockage (low reverse current) and ground pin current that is nearly.
NCP348 : The NCP348 is able to disconnect the systems from its output pin in case wrong input operating conditions are detected. The system is positive overvoltage protected up to +28 V. Due to this device using internal NMOS, no external device is necesary, reducing the system cost and the PCB area of the application board. The NCP348 is able to instantaneously.